Product details
About this part
Front brake pad set MR475453, also catalogued as MN102615 and under FMSI number 23487, is the front pad for the small Mitsubishi four wheel drives: the Pajero Pinin and Pinin 1.8 GDI, the Pajero Mini and Pajero Junior kei cars, the Pajero Sport and Pajero II, the L200 pickup and the Galant VIII saloon, from 1990 to 2012.
The set is four pads for the single piston floating front calipers used across this range, with a steel backing plate, a moulded friction block and an integral anti squeal shim pressed onto the back. The friction compound is a semi metallic mix with a high graphite content so it copes with the constant light brake, release, brake cycle of a short wheelbase off roader on loose ground, and the pad edges are chamfered to stop the low speed squeak these calipers are known for. Both pads in a pair are identical, so the set can be fitted either side up.
How they fail. The front pads on a Pinin or Mini wear from the outside in because the sliding caliper pins stop sliding, and the inner pad then sits against the disc while the outer one barely touches it. Owners notice a pull to one side under braking, a wheel that is hot after a short drive and a pedal that needs a second pump. Mud and grit from green laning grind the pad face and leave a scored band on the disc, and a pad that has been down to the rivets shows a bright ring on the disc edge and a grinding noise that disappears when the brakes are released. A pad that has separated from its plate is scrap and the disc must be checked for cracks around the holes on drilled versions.
Fitting notes. Loosen the wheel nuts, raise the front, and support it on stands before the caliper comes off. Open the bleed nipple briefly to push the piston back, which keeps dirty fluid out of the ABS unit, or use a syringe on the reservoir. Wire brush the caliper bracket abutments until the new pad ears slide without force, grease the slide pins with high temperature silicone grease, and fit new anti rattle clips. Torque the bracket bolts to the figure in the manual, refit the wheel, pump the pedal hard before the vehicle moves, and bed the pads in with gentle stops for the first 200 km. Check the brake fluid level afterwards.
Supplied as one axle set of four pads with shims and anti rattle clips. Twelve month warranty.
Frequently asked questions
Q: What kind of parts do you supply?
A: We are a trading company, auto parts supplier, and sourcing partner. We source fuel pump assemblies, filters, ignition coils, injectors, sensors, connector wires and other automotive parts through relevant suppliers. We are not a manufacturer; product and supplier details are confirmed for each quotation.
Q: Do you test all your goods before delivery?
A: Inspection and sample arrangements depend on the product and order. We can coordinate supplier documents, photos, samples, or pre-shipment inspection when included in the quotation. Please confirm the required scope before ordering.
Q: How long is the delivery time?
A: Lead time depends on supplier availability, product requirements, quantity, packing, and destination. The applicable lead time is stated in the quotation or order confirmation.
Q: What is your terms of packing?
A: Neutral packing is our standard: goods are packed in neutral white boxes and brown cartons. If you have a legally registered patent, we can pack the goods in your branded boxes after receiving your authorization letters. Above a minimum order quantity we also handle custom packaging and help with the design: printed color boxes, color labels, anti-counterfeit / security labels, and even small promotional items such as branded pens, mugs, baseball caps and T-shirts with your logo. Tell us your order quantity and requirements and we will confirm exactly what can be customized for your order.
Q: How can I get the warranty?
A: First of all, please take a photo when you receive the goods to confirm that the goods are in good condition, and then contact our sales, send the photo to us, we will record for you.