Browse 104 Clock Spring part numbers with OE cross-reference and fitment notes for passenger cars, SUVs, pickups and vans. Export packing available - send an inquiry for price and lead time.
A clock spring, also sold as a spiral cable or airbag squib, is the wound ribbon inside the steering wheel that keeps the horn, the airbag and the multifunction buttons connected while the wheel turns. It has a fixed number of turns of travel in each direction, and it fails either because the ribbon has been flexed past that limit or because the connector at the back of the wheel has been pulled.
This category carries 104 references indexed by OE number: 25554-2ZY9E for Nissan applications, B55541VA8A for Nissan Juke, 934902T325 for Kia K5, 971953513M for Porsche Panamera, 6G9N-3F975-BC for Land Rover Freelander 2, and 10147490-04 for Tesla Model 3.
Three details have to match. The first is the number of turns and the connector layout, because two springs that look identical from the front can carry different pin counts for a heated wheel or for paddle shifters. The second is whether the steering angle sensor is built into the spring, which has to be the correct type or the stability control lamp will stay on. The third is whether the spring is supplied with its centre lock pin in place, because a spring that has been turned before fitting is already scrap.
The failure shows up as an airbag warning lamp, a horn that stops working, or steering wheel buttons that only respond at certain angles. Before fitting, straighten the front wheels, keep the steering column locked and do not rotate the wheel with the spring removed. Most new springs ship with a locking pin that is pulled out only after the wheel is seated on the splines.
Quote by OE number, model year, and whether the car has a heated steering wheel or paddle shifters, and state the pin count if the old spring is still available to photograph. A spring with the wrong pin count leaves those functions dead even though the airbag circuit itself works.
No. The ribbon is a continuous conductor with a set number of turns, and a repaired or re-centred ribbon has already lost part of its travel. A repaired spring typically fails again within a few months, often taking the horn and airbag circuit with it.
Either the spring is not the correct variant for a car with a steering angle sensor, or the fault codes have not been cleared. The angle sensor has to be calibrated with a diagnostic tool on most vehicles after the spring is replaced.
Yes. The airbag circuit is live whenever the battery is connected, and the connector at the back of the wheel should be released only after the battery has been disconnected and the system allowed to discharge.
A new spring is supplied centred and locked with a pin or a tape band. Fit the wheel first, then remove the lock. Turning the spring more than half a turn in either direction before the wheel is seated is the most common way a new spring is destroyed on installation.
Tell us the OE numbers, quantities and destination port. We confirm fitment against your references and quote with export packing options.