Product details
About this part
E1EF12029AA, sold in the trade as FD478, is not a pencil coil at all: it is the round oil filled canister coil that Ford used on the distributor ignition of the 4.9 straight six, the 5.0 and 5.8 V8 and the 3.0 and 3.8 V6 from the early eighties into the late nineties. One coil serves the whole engine, sending its high tension down a single lead to the centre of the distributor cap, and the distributor does the rest.
The can is a steel cylinder about 75 mm across with a laminated iron core, a primary and secondary winding immersed in insulating oil, and a tower on top with a deep recess for the HT lead. The oil does two jobs: it insulates the windings and it carries heat from the core to the can, which is why a coil that has been run low on oil, usually after a leak at the tower seal, fails suddenly when hot. The primary is around 1 ohm and the secondary around 8 kohm, and the can is earthed through its mounting strap, so a corroded strap is enough to stop the engine.
Failure on these old Fords is usually a no start after the engine has been running, or a dead miss that affects every cylinder at once because there is only one coil. The can will be hot to the touch, sometimes hotter than the surrounding metal, and the tower may show a carbon track where the HT lead has been arcing. A cracked can, oil weeping from the tower or a bulging top all mean replacement. Because the coil feeds a distributor, a bad cap, rotor or plug lead can look like a bad coil, so check the secondary circuit end to end before condemning the coil.
Disconnect the battery, pull the HT lead out of the tower by the boot and not the wire, unplug the primary connector and undo the mounting screws. Clean the mounting surface so the new coil has a good earth, fit the can with the strap tight, and push the HT lead in until it clicks. Check the resistance of the leads and the condition of the cap and rotor while the coil is off. Start the engine and let it idle for ten minutes, then check that the can is warm but not too hot to touch.
Supplied as one oil filled canister coil. Twelve month warranty.
Frequently asked questions
Q: What kind of parts do you supply?
A: We are a trading company, auto parts supplier, and sourcing partner. We source fuel pump assemblies, filters, ignition coils, injectors, sensors, connector wires and other automotive parts through relevant suppliers. We are not a manufacturer; product and supplier details are confirmed for each quotation.
Q: Do you test all your goods before delivery?
A: Inspection and sample arrangements depend on the product and order. We can coordinate supplier documents, photos, samples, or pre-shipment inspection when included in the quotation. Please confirm the required scope before ordering.
Q: How long is the delivery time?
A: Lead time depends on supplier availability, product requirements, quantity, packing, and destination. The applicable lead time is stated in the quotation or order confirmation.
Q: What is your terms of packing?
A: Neutral packing is our standard: goods are packed in neutral white boxes and brown cartons. If you have a legally registered patent, we can pack the goods in your branded boxes after receiving your authorization letters. Above a minimum order quantity we also handle custom packaging and help with the design: printed color boxes, color labels, anti-counterfeit / security labels, and even small promotional items such as branded pens, mugs, baseball caps and T-shirts with your logo. Tell us your order quantity and requirements and we will confirm exactly what can be customized for your order.
Q: How can I get the warranty?
A: First of all, please take a photo when you receive the goods to confirm that the goods are in good condition, and then contact our sales, send the photo to us, we will record for you.