Product details
About this part
Ignition coil 1L8Z-12029-AB, also sold as DG513 and FD502, is the coil on plug unit for the Ford and Mazda 3.0 litre Duratec and AJ V6 in the Escape, Maverick, Five Hundred, Taurus, Tribute, MPV, Mazda 6, Mercury Mariner, Sable and Montego, from 1995 to 2012.
The V6 takes six of these, one on top of each plug, so the box contains a single coil and a full set is six. Each unit is a short black tower with a two pin connector on one side, a mounting eye at the top that takes one bolt, and a long boot that pushes down through the cam cover into the plug well. The secondary winding and the igniter are potted together in the head, and the boot has an internal spring that clips onto the plug terminal so the coil can be pulled off by hand without tools. On these engines the coil sits in a cast recess in the cover with a rubber seal around the top of the boot, which is what keeps the well dry.
How they fail. A misfire that starts as a slight stumble when the engine is cold and turns into a hard shake and a flashing check engine light is the usual story, with a P030x code naming one cylinder. The point where these coils fail first is the boot: it hardens with age, loses its seal, and water from rain or a wash runs straight down into the well, after which the spark tracks along the silicone and the plug rusts in place. Heat from the rear bank on a Tribute or Escape cooks the potting until the coil cracks across the top, and then it fails hot and works again when cold. An engine that has been run with a badly worn plug will often kill its coil within a few thousand kilometres because the wider gap needs more voltage than a tired winding can supply.
Fitting notes. Let the engine cool, unclip the connector with its release tab, undo the single bolt and pull the coil straight up, twisting slightly if the boot is stuck. If the boot stays in the well, pull it out with long nose pliers and make sure no pieces are left behind. Blow the well clean, inspect the plug, and replace plugs as a set of six, not one at a time, because a new coil paired with a worn plug will not last. Apply dielectric grease inside the new boot, push the coil down until it seats, and tighten the bolt to 8 Nm. Do the same on all six if two or more are suspect, and clear the codes afterwards.
Supplied as one coil with boot and spring. Six are needed per vehicle and are ordered separately. Twelve month warranty.
Frequently asked questions
Q: What kind of parts do you supply?
A: We are a trading company, auto parts supplier, and sourcing partner. We source fuel pump assemblies, filters, ignition coils, injectors, sensors, connector wires and other automotive parts through relevant suppliers. We are not a manufacturer; product and supplier details are confirmed for each quotation.
Q: Do you test all your goods before delivery?
A: Inspection and sample arrangements depend on the product and order. We can coordinate supplier documents, photos, samples, or pre-shipment inspection when included in the quotation. Please confirm the required scope before ordering.
Q: How long is the delivery time?
A: Lead time depends on supplier availability, product requirements, quantity, packing, and destination. The applicable lead time is stated in the quotation or order confirmation.
Q: What is your terms of packing?
A: Neutral packing is our standard: goods are packed in neutral white boxes and brown cartons. If you have a legally registered patent, we can pack the goods in your branded boxes after receiving your authorization letters. Above a minimum order quantity we also handle custom packaging and help with the design: printed color boxes, color labels, anti-counterfeit / security labels, and even small promotional items such as branded pens, mugs, baseball caps and T-shirts with your logo. Tell us your order quantity and requirements and we will confirm exactly what can be customized for your order.
Q: How can I get the warranty?
A: First of all, please take a photo when you receive the goods to confirm that the goods are in good condition, and then contact our sales, send the photo to us, we will record for you.